Store Front > Classic Z/ZX Parts Home > Ignition / Tune Up Kits > Performance Ignition Systems > PerTronix Ignition Kit, 70-73 240Z w/ Manual Transmission

Share:

| More

Note: Not sure which Ohm coil you need? See the Coil Notes section on this page for info.

PerTronix Ignition Kit, 70-73 240Z w/ Manual Transmission
	Quantity in Basket:none Code: 12-4020 Price:$123.95
	Coil: 1.5 Ohm Black 1.5 Ohm Chrome 3.0 Ohm Black 3.0 Ohm Chrome
	Quantity:
Installation Note: The trigger cylinder that fits on the center shaft of your distributor (under the coil) has a strip of green tape around it, as seen in the pictures above. DO NOT REMOVE THIS TAPE! The tape holds the pickups for the trigger in place and should never be removed. Description: Get the best combination right off the bat and save a buck. This PerTronix Ignition Kit includes the Ignitor, as well as a Flame-Thrower® 40,000 volt coil in your choice of black or chrome. See below for more details on each part. For individual parts, see related items below. Ignitor Description: A solid-state electronic ignition system. Never change points again! The Ignitor by PerTronix has proven itself for over 30 years in applications ranging from race cars to tractors. The Ignitor replaces the points in your 240Z (single point distributors only) with a dependable, self contained and maintenance free electronic ignition system. The Ignitor has been called the "stealth" ignition because of its quick installation and nearly undetectable presence under your distributor cap. Stock Distributor & Rotor not included. Delivers twice the voltage to the spark plugs, increasing horsepower, fuel economy, and spark plug life 2:1 improvement over points in current fall time for increased coil output Rotating cobalt magnets trigger a Hall Effect integrated circuit. No points to burn, no moving parts to wear out Epoxy molding makes our module impervious to dirt, oil, grease and moisture Fits entirely inside the distributor No "black box" to clutter the engine compartment Stable timing-no need for any adjustments No complicated wiring makes installation easy RPM Range: 0 to 15,000 RPM Temperature Range: -50 to 300F Works with stock 240Z coil For optimal performance use with Flame-Thrower® 40,000 volt coil (see related items below) Legal in all 50 states and Canada (C.A.R.B. E.O. #D-57-2) Guaranteed by PerTronix for 30 months Works great as a trigger for multi-spark CD ignitions, like our Hi-6S (see related items below) Not for dual-point distributors Coil Notes: The only performance coils that should be used with the PerTronix Ignitor, the 40,000 volt Flame-Thrower canister coil's higher voltage allows larger spark plug gaps for added power, smoother response and better fuel economy. They are oil filled for great heat control, and internally resisted. Legal in all 50 states and Canada (C.A.R.B. E.O. #D-57-10). The 3.0 Ohm coil is not for use with the factory (or any other) ballast resistor. If your setup requires you to keep the ballast resistor, please select the 1.5 Ohm coil above (see Related Items below for more information about the 1.5 Ohm PerTronix coils). Installation Note: The PerTronix coil in this kit is approximately 56 mm in diameter. Installation may be possible with your current bracket (see "Original Brackets" below), or simply add a Chrome Bracket, or Chrome Coil Cover & Bracket, from Related Items below, both of which will work properly with this coil. Original Brackets: Original 240Z coils (and many replacements) were a little smaller than the Pertronix coil included in this kit. If you have an original 240Z bracket, you may need to obtain a longer adjustment screw to use your original bracket. Some replacement coils available over the years may have been smaller or larger. Even Nissan original parts often varied, so base your decision on your current coil's diameter, and the adjustment remaining in your current bracket in either direction. If you have any questions, just give us a call. Note: Automatic transmission models came equipped with Dual Point distributors. If you currently have a dual point distributor, you will need to locate and install a single point distributor from a manual transmission model in order to use this kit. This kit will NOT work with dual point distributors. Please give us a call if you are not sure whether you have a dual point or single point distributor in your car. Model Guide: Datsun 240Z Code Guide: Datsun S30 Year Guide: 1970, 1971, 1972, 1973

Related Item(s)

Chrome Ignition Coil Cover & Bracket, 70-83 Z/ZX Code:10-2065 Price: $12.95 Quantity in Basket: none PerTronix Ignitor, 70-73 240Z Code:12-4019 Price: $89.95 Quantity in Basket: none PerTronix 3.0 Ohm Coil, Black, 70-83 Z/ZX Code:12-4061 Price: $39.95 Quantity in Basket: none PerTronix 3.0 Ohm Coil, Chrome, 70-83 Z/ZX Code:12-4062 Price: $39.95 Quantity in Basket: none Chrome Coil Bracket, 70-83 Z/ZX* Code:10-2070 Price: $8.95 Quantity in Basket: none PerTronix 1.5 Ohm Coil, Chrome, 70-83 Z/ZX Code:12-4060 Price: $39.95 Quantity in Basket: none PerTronix 1.5 Ohm Coil, Black, 70-83 Z/ZX Code:12-4059 Price: $39.95 Quantity in Basket: none