As any early Z-Car owner can likely confirm, broken studs and bolts are not fun to remove from aluminum parts. One of the best ways to prevent broken bolts is to replace hardware before it breaks during removal. This genuine, original equipment (OEM) bolt is used to hold the Crankshaft Position Sensor to the driver's side of the upper oil pan on DE engines (05-06) and to the passenger side of the engine block on HR engines (07-19). Sold individually; see the list below for quantity and torque spec.
This bolt has a very low torque spec for installation. We recommend installing the bolt by hand first (but only until resistance is felt), then follow the factory torque spec using an inch-pound specific torque wrench.
- 05-06 Torque Spec: 85 in-lb.
- 07-19 Torque Spec: 62 in-lb.
03-04 model 350Z's use the same bolt for the Crankshaft Position Sensor as the Camshaft Position Sensors. Give us a call if you need this bolt for your 03-04 model.
Nissan 350Z, 370Z
Nissan Z33, Z34
2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019